ASTM A1039/A1039M-10
- Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process
- standard by ASTM International, 10/01/2010
- Publisher: ASTM
$26.00$52.80
1.1 This specification covers commercial and structural steel sheet in coils and cut lengths produced by the twin-roll casting process.
1.2 The steel sheet is available in the designations listed in Section 4.
1.3 The material is available in the following sizes:
| Thickness-0.027 in. [0.7 mm] to 0.078 in. [2.0 mm] |
| Width-up to 79 in. [2000 mm] |
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1 - A description of the Twin-Roll Casting Process is included in Appendix X1.
Related Products
ASTM D5173-15
Standard Guide for On-Line Monitoring of Total Organic Carbon in Water by Oxidation and Detection ..
$22.00 $44.00
ASTM F715-07(2012)
Standard Test Methods for Coated Fabrics Used for Oil Spill Control and Storage..
$20.00 $39.00
ASTM D4828-94(1999)
Standard Test Methods for Practical Washability of Organic Coatings..
$23.00 $46.80