Provide PDF Format
ASTM A455/A455M-12a
- Standard Specification for Pressure Vessel Plates, Carbon Steel, High-Strength Manganese
- standard by ASTM International, 11/01/2012
- Publisher: ASTM
$20.00$39.00
This specification covers high-tensile strength carbon-manganese steel plates intended for welded pressure vessels.
1.2 This steel is usually made to a semi-killed or capped deoxidation practice; however, at the purchaser's or the steel producer's option, the steel may be made silicon-killed or aluminum-killed.
1.3 The maximum thickness of plates furnished under this specification shall be ¾ in. [20 mm].
1.4 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.2 This steel is usually made to a semi-killed or capped deoxidation practice; however, at the purchaser's or the steel producer's option, the steel may be made silicon-killed or aluminum-killed.
1.3 The maximum thickness of plates furnished under this specification shall be ¾ in. [20 mm].
1.4 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Related Products
ASTM C303-10
Standard Test Method for Dimensions and Density of Preformed Block and Board-Type Thermal Insulation..
$20.00 $39.00
ASTM B455-10
Standard Specification for Copper-Zinc-Lead Alloy (Leaded-Brass) Extruded Shapes..
$20.00 $39.00
ASTM E2499-06
Standard Practice for Classification of Equipment Physical Location Information..
$23.00 $46.80
