• ASTM A815/A815M-04
Provide PDF Format

Learn More

ASTM A815/A815M-04

  • Standard Specification for Wrought Ferritic, Ferritic/Austenitic, and Martensitic Stainless Steel Piping Fittings
  • standard by ASTM International, 05/01/2004
  • Publisher: ASTM

$26.00$52.80


1.1 This specification covers two general classes, WP and CR, of wrought ferritic, ferritic/austenitic, and martensitic stainless steel fittings of seamless and welded construction covered by the latest revision of Specification A 960. Fittings differing from these standards may be furnished in accordance with Supplementary Requirement S8.

1.1.1 Class WP fittings are subdivided into four subclasses: Classes WP-S, WP-W, WP-WX, and WP-WU. They are manufactured to the requirements of Specification A 960, and they shall have pressure ratings compatible with 12.2. Class WP-S fittings are those manufactured from seamless product by a seamless method of manufacture (marked with class symbol WP-S); Class WP-W fittings are those which contain welds where the fitting fabrication or construction welds have been radiographed (marked with class symbol WP-W); and Class WP-WX fittings are those which contain welds where all welds have been radiographed (marked with class symbol WP-WX); and Class WP-WU fittings are those which contain welds where all welds have been ultrasonically tested (marked with class symbol WP-WU).

1.1.2 Class CR fittings are those manufactured to the requirements of MSS SP-43, and they shall have pressure ratings compatible with 12.3.

1.2 This specification does not apply to cast fittings.

1.3 Optional supplementary requirements are provided. When desired, one or more of these may be specified in the order.

1.4 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable "M" specification designation [SI units], the material shall be furnished to inch-pound units.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Related Products

ASTM D5213-99

ASTM D5213-99

Standard Specification for Polymeric Resin Film for Electrical Insulation and Dielectric Application..

$26.00 $52.80

ASTM E967-03

ASTM E967-03

Standard Practice for Temperature Calibration of Differential Scanning Calorimeters and Differential..

$23.00 $46.80

ASTM D1734-93(2003)

ASTM D1734-93(2003)

Standard Practice for Making Cementitious Panels for Testing Coatings..

$23.00 $46.80

ASTM C496-96

ASTM C496-96

Standard Test Method for Splitting Tensile Strength of Cylindrical Concrete Specimens..

$23.00 $46.80