ASTM C836/C836M-10
- Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course
- standard by ASTM International, 02/01/2010
- Publisher: ASTM
$23.00$46.80
1.1 This specification describes the required properties and test methods for a cold liquid-applied elastomeric-type membrane, one- or two-component, for waterproofing building decks and walls subject to hydrostatic pressure in building areas to be occupied by personnel, vehicles, or equipment. This specification applies only to a membrane system that will be covered with a separate wearing course, traffic course, or backfill.
Note 1 - See Guide C898 and Guide C1471 for proper application of membrane.
1.2 There are no ISO standards similar or equivalent to this ASTM standard.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Related Products
ASTM D2041-00
Standard Test Method for Theoretical Maximum Specific Gravity and Density of Bituminous Paving Mixtu..
$23.00 $46.80
ASTM F708-92(1997)
Standard Practice for Design and Installation of Rigid Pipe Hangers..
$30.00 $60.00
ASTM A185/A185M-05a
Standard Specification for Steel Welded Wire Reinforcement, Plain, for Concrete..
$26.00 $52.80