ASTM D4310-06b
- Standard Test Method for Determination of Sludging and Corrosion Tendencies of Inhibited Mineral Oils
- standard by ASTM International, 12/01/2006
- Publisher: ASTM
$30.00$60.00
1.1 This test method is used to evaluate the tendency of inhibited mineral oil based steam turbine lubricants and mineral oil based anti-wear hydraulic oils to corrode copper catalyst metal and to form sludge during oxidation in the presence of oxygen, water, and copper and iron metals at an elevated temperature. The test method is also used for testing circulating oils having a specific gravity less than that of water and containing rust and oxidation inhibitors. Note 1During round robin testing copper and iron in the oil, water and sludge phases were measured. However, the values for the total iron were found to be so low (that is, below 0.8 mg), that statistical analysis was inappropriate. The results of the cooperative test program are available.
1.2 This test method is a modification of Test Method D 943 where the oxidation stability of the same kinds of oils is determined by following the acid number of oil. The number of test hours required for the oil to reach an acid number of 2.0 mg KOH/g is the oxidation lifetime.
1.3 Procedure A of this test method requires the determination and report of the weight of the sludge and the total amount of copper in the oil, water, and sludge phases. Procedure B requires the sludge determination only. The acid number determination is optional for both procedures.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Related Products
ASTM C1138M-05
Standard Test Method for Abrasion Resistance of Concrete (Underwater Method)..
$23.00 $46.80
ASTM D1304-99
Standard Test Methods for Adhesives Relative to Their Use as Electrical Insulation..
$23.00 $46.80
ASTM A167-99
Standard Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Stri..
$23.00 $46.80