ASTM D4310-10(2015)
- Standard Test Method for Determination of Sludging and Corrosion Tendencies of Inhibited Mineral Oils
- standard by ASTM International, 10/01/2015
- Publisher: ASTM
$25.00$50.00
1.1 This test method covers and is used to evaluate the tendency of inhibited mineral oil based steam turbine lubricants and mineral oil based anti-wear hydraulic oils to corrode copper catalyst metal and to form sludge during oxidation in the presence of oxygen, water, and copper and iron metals at an elevated temperature. The test method is also used for testing circulating oils having a specific gravity less than that of water and containing rust and oxidation inhibitors.
Note 1: During round robin testing copper and iron in the oil, water and sludge phases were measured. However, the values for the total iron were found to be so low (that is, below 0.8 mg), that statistical analysis was inappropriate. The results of the cooperative test program are available (see Section 16).
Related Products
ASTM E273-15
Standard Practice for Ultrasonic Testing of the Weld Zone of Welded Pipe and Tubing..
$22.00 $44.00
ASTM D635-98
Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizont..
$26.00 $52.80
ASTM F2135-01
Standard Specification for Molded Drain, Waste, and Vent (DWV) Short-Pattern Plastic Fittings..
$26.00 $52.80
ASTM B77-07(2013)
Standard Test Method for Thermoelectric Power of Electrical-Resistance Alloys..
$20.00 $39.00