• ASTM D7391-09
Provide PDF Format

Learn More

ASTM D7391-09

  • Standard Test Method for Categorization and Quantification of Airborne Fungal Structures in an Inertial Impaction Sample by Optical Microscopy
  • standard by ASTM International, 05/01/2009
  • Publisher: ASTM

$25.00$50.00


1.1 This test method is a procedure that uses direct microscopy to analyze the deposit on an inertial impaction sample.

1.2 This test method describes procedures for categorizing and enumerating fungal structures by morphological type. Typically, categories may be as small as genus (for example, Cladosporium) or as large as phylum (for example, basidiospores).

1.3 This method contains two procedures for enumerating fungal structures: one for slit impaction samples and one for circular impaction samples. This test method is applicable for impaction air samples, for which a known volume of air (at a rate as recommended by the manufacturer) has been drawn, and is also applicable for blank impaction samples.

1.4 Enumeration results are presented in fungal structures/sample (fs/sample) and fungal structures/m³ (fs/m³).

1.5 The range of enumeration results that can be determined with this method depends on the size of the spores on the sample trace, the amount of particulate matter on the sample trace, the percentage of the sample trace counted, and the volume of air sampled.

1.6 This method addresses only the analysis of samples. The sampling process and interpretation of results is outside the scope of this method.

1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Related Products

ASTM D7229-06

ASTM D7229-06

Standard Test Method for Preparation and Determination of the Bulk Specific Gravity of Dense-Graded ..

$23.00 $46.80

ASTM F899-09e1

ASTM F899-09e1

Standard Specification for Wrought Stainless Steels for Surgical Instruments..

$26.00 $52.80

ASTM B493/B493M-08e1

ASTM B493/B493M-08e1

Standard Specification for Zirconium and Zirconium Alloy Forgings..

$23.00 $46.80

ASTM D4677-87(2007)

ASTM D4677-87(2007)

Standard Classification for Rubber Compounding Materials-Titanium Dioxide..

$23.00 $46.80