ASTM D7680-10
- Standard Practice for Preparing Prints of Paste Printing Inks by a Motor-Driven Printability Tester
- standard by ASTM International, 12/01/2010
- Publisher: ASTM
$22.00$44.00
1.1 This practice describes the procedure for preparing laboratory prints of paste printing inks using a motor-driven printability tester.
1.2 This practice covers printability testers of four different designs, referred to as Tester A, B, C, and D. These testers feature "push-button" control of printing speed and pressure and facilitate measurement of exact ink film thickness.
1.3 This practice is intended primarily for lithographic and letterpress inks that dry by oxidation or penetration. With appropriate drying or curing equipment, it is also applicable to other systems such as heat-set or energy curable.
1.4 This practice is applicable to the preparation of single-color solid-area prints by dry offset (also know as letterset) or by letterpress on any flat surface including paper, paperboard, plastic film, textiles, and metal.
1.5 The values stated in SI units are to be regarded as the standard. The only other unit of measurement used is fpm.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Related Products
ASTM D925-14
Standard Test Methods for Rubber Property—Staining of Surfaces (Contact, Migratio..
$22.00 $44.00