• ASTM E119-05
Provide PDF Format

Learn More

ASTM E119-05

  • Standard Test Methods for Fire Tests of Building Construction and Materials
  • standard by ASTM International, 09/15/2005
  • Publisher: ASTM

$38.00$76.80


1.1 The test methods described in this fire-test-response standard are applicable to assemblies of masonry units and to composite assemblies of structural materials for buildings, including bearing and other walls and partitions, columns, girders, beams, slabs, and composite slab and beam assemblies for floors and roofs. They are also applicable to other assemblies and structural units that constitute permanent integral parts of a finished building.

1.2 It is the intent that classifications shall register comparative performance to specific fire-test conditions during the period of exposure and shall not be construed as having determined suitability for use under other conditions or after fire exposure.

1.3 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products or assemblies under actual fire conditions.

1.4 These test methods prescribe a standard fire exposure for comparing the test results of building construction assemblies. The results of these tests are one factor in assessing predicted fire performance of building construction and assemblies. Application of these test results to predict the performance of actual building construction requires the evaluation of test conditions.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.6 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

Related Products

ASTM D3634-99(2009)

ASTM D3634-99(2009)

Standard Test Method for Trace Chloride Ion in Engine Coolants..

$23.00 $46.80

ASTM D5464-11

ASTM D5464-11

Standard Test Method for pH Measurement of Water of Low Conductivity..

$30.00 $60.00

ASTM D6681-04

ASTM D6681-04

Standard Test Method for Evaluation of Engine Oils in a High Speed, Single-Cylinder Diesel Engine-Ca..

$43.00 $85.20

ASTM B584-09a

ASTM B584-09a

Standard Specification for Copper Alloy Sand Castings for General Applications..

$26.00 $52.80