• ASTM E855-90(2000)
Provide PDF Format

Learn More

ASTM E855-90(2000)

  • Standard Test Methods for Bend Testing of Metallic Flat Materials for Spring Applications Involving Static Loading
  • standard by ASTM International, 01/01/2000
  • Publisher: ASTM

$26.00$52.80


1.1 This standard describes three test methods for determining the modulus of elasticity in bending and the bending strength of metallic strips or sheets intended for the use in flat springs:

1.1.1 Test Method A--a cantilever beam,

1.1.2 Test Method B--a three-point loaded beam (that is, a beam resting on two supports and centrally loaded), and

1.1.3 Test Method Ca four-point loaded beam (that is, a beam resting on two supports and loaded at two points equally spaced from each support).

1.2 Values stated in inch-pound units are to be regarded as the standard. SI units are provided for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Related Products

ASTM D3634-99(2009)

ASTM D3634-99(2009)

Standard Test Method for Trace Chloride Ion in Engine Coolants..

$23.00 $46.80

ASTM D5464-11

ASTM D5464-11

Standard Test Method for pH Measurement of Water of Low Conductivity..

$30.00 $60.00

ASTM D6681-04

ASTM D6681-04

Standard Test Method for Evaluation of Engine Oils in a High Speed, Single-Cylinder Diesel Engine-Ca..

$43.00 $85.20

ASTM B584-09a

ASTM B584-09a

Standard Specification for Copper Alloy Sand Castings for General Applications..

$26.00 $52.80