• AWWA ACE61828
Provide PDF Format

Learn More

AWWA ACE61828

  • To Lift or Boost? Modifying the Operation of an Existing Pump Station to Maximize Energy Efficiency
  • Conference Proceeding by American Water Works Association, 06/17/2005
  • Publisher: AWWA

$12.00$24.00


At the Greater Cincinnati Water Works (GCWW), energy management is an importantcomponent of operating all pumping facilities. During a recent energy managementanalyses of a 35 mgd pump station, it was determined that significant energy savingscould be achieved if the pumping operation was radically changed. The normal operationof the facility was a "dump and pump" operation, where the water from the upstreamdistribution system fills the reservoir, and then the water is pumped from the reservoir tothe next pressure zone. Because the inlet pressures to the reservoir were significantlyhigher than anticipated (70 psi versus 20 psi), an innovative solution was developed toconvert the pump station from a "dump and pump" operation to a booster pumpoperation. Extensive hydraulic and economic analyses were performed to determine if theexisting pumps could be modified to efficiently operate as booster pumps, therebylowering the required horsepower usage and capturing significant energy savings.However, the pump's ability to also operate as a lift pump had to be maintained tocontinue using part of the 2.5 MG storage reservoir for water quality purposes. Thehydraulic analyses showed that by carefully trimming the pump impellers, the pumpscould be converted to pump efficiently in both the booster mode and the lift mode. Theeconomic analysis showed that the cost of modifying the existing pumps could berecovered with the projected energy savings in less than three years. The long-termelectrical savings were estimated at about 20 percent of the current electrical costs. Also,the 70-psi inlet pressure had to be reduced to about 10 psi before entering the reservoir.Throttling the water into the reservoir was causing premature failure of a critical inletvalve and resulted in undesirable pressure fluctuations on the upstream distributionsystem. In conjunction with the pump modifications, the control valve to the reservoirinlet was replaced with a unique valve called a sleeve valve. Includes tables, figures.

Related Products

AWWA SRC57776

AWWA SRC57776

National Rural Water Association's Source Water Protection Efforts..

$12.00 $24.00

AWWA MTC50234

AWWA MTC50234

The Effect of Surfactants on the Microscale Architecture of Biofilms Formed on Polymer Separation Me..

$12.00 $24.00

AWWA WQTC55175

AWWA WQTC55175

Simultaneous Determination of 1,4 Dioxane and N-Nitrosodimethylamine From Drinking Water by GC/MS Us..

$12.00 $24.00

AWWA CSC94006

AWWA CSC94006

Computer Assisted Peak Shaving Saves Operating Dollars..

$12.00 $24.00