Provide PDF Format
PRCI NG-18 Report 175
- Proof Testing of the Pre-Hot-Tap Branch Connection
- Report / Survey by Pipeline Research Council International, 08/01/1989
- Publisher: PRCI
$198.00$395.00
L51561e
Battelle Columbus Division
Need: Proof testing of a hot tap prior to completing the actual tap has, in the past, been an individual company procedure. These proof testing procedures have varied from a low pressure leak test to a high pressure test that has reportedly, in a few cases, caused a rupture through the enclosed circular segment of the main line pipe. The objective of this research was to determine a safe and reasonable test pressure level to apply to the attached branch line before completion of the tap. It is aimed at optimizing the safety of hot tap installations while minimizing the chances of damage to the carrier pipe.
Result: An analytical model was developed to predict the elastic response of a critical location of the hot tap joint under proof test conditions. Two experiments instrumented with strain gages were conducted. The strain gages were placed in critical locations to determine which area is most highly strained and to help determine the maximum pressure level to be applied in the test. It was not desired to cause a rupture in these experiments, but the pressure level was taken higher than the "safe and reasonable test pressure" to obtain information that would bracket this test pressure level. Full-scale instrumented pressure tests were then conducted on 30-inch X60 run pipe with three tap sizes. The tests showed the analysis to be accurate for ratios of branch pipe diameter to run pipe diameter greater than 0.3, approximately, and conservative for branch pipes smaller than this value. This provides a basis for establishing a safe hot tap uniform proof test procedure which minimizes the chances of damage to the run pipe.
Benefit: The benefit of this study and recommended practice is optimizing the safety of hot tap installations while minimizing the chances of damage to the carrier pipe
Battelle Columbus Division
Need: Proof testing of a hot tap prior to completing the actual tap has, in the past, been an individual company procedure. These proof testing procedures have varied from a low pressure leak test to a high pressure test that has reportedly, in a few cases, caused a rupture through the enclosed circular segment of the main line pipe. The objective of this research was to determine a safe and reasonable test pressure level to apply to the attached branch line before completion of the tap. It is aimed at optimizing the safety of hot tap installations while minimizing the chances of damage to the carrier pipe.
Result: An analytical model was developed to predict the elastic response of a critical location of the hot tap joint under proof test conditions. Two experiments instrumented with strain gages were conducted. The strain gages were placed in critical locations to determine which area is most highly strained and to help determine the maximum pressure level to be applied in the test. It was not desired to cause a rupture in these experiments, but the pressure level was taken higher than the "safe and reasonable test pressure" to obtain information that would bracket this test pressure level. Full-scale instrumented pressure tests were then conducted on 30-inch X60 run pipe with three tap sizes. The tests showed the analysis to be accurate for ratios of branch pipe diameter to run pipe diameter greater than 0.3, approximately, and conservative for branch pipes smaller than this value. This provides a basis for establishing a safe hot tap uniform proof test procedure which minimizes the chances of damage to the run pipe.
Benefit: The benefit of this study and recommended practice is optimizing the safety of hot tap installations while minimizing the chances of damage to the carrier pipe
Related Products
PRCI PR-12-75
A Microseismic Study of an Underground Natural Gas Storage Reservoir Volume 2 - Compilation of Field..
$198.00 $395.00
PRCI PR-185-9515
Repair of Pipelines by Direct Deposition of Weld Metal--Further Studies..
$698.00 $1,395.00
PRCI Report 177
Mechanics-Based Analysis of Stress-Corrosion Cracking of Line-Pipe in a Carbonate-Bicarbonate Enviro..
$175.00 $349.00