Provide PDF Format
SAE AMS2251H
- Tolerances Low-Alloy Steel Bars
- standard by SAE International, 09/14/2006
- Publisher: SAE
$37.00$74.00
This specification covers established inch/pound manufacturing tolerances applicable to low-alloy steel bars ordered to inch/pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term "exclusive" is used to apply only to the higher figure of the specified range. No clear cut demarcation is available to differentiate between bar and wire products, so no definitions of these products are included.
Related Products
SAE AMS7261/1F
Rings, Sealing, Phosphonitrilic (Fz) Fluoroelastomer, High-Temperature-Fluid Resistant, 65-75 (Cance..
$37.00 $74.00
SAE AMS4117K
Aluminum Alloy, Rolled or Cold Finished Bars, Rods, and Wire and Flash Welded Rings 1.0Mg - 0.60Si -..
$37.00 $74.00
