Provide PDF Format
SAE J2337/1_200908
- Connections for Fluid Power and High Pressure Use--Ports, Stud Ends, and Plugs with ISO 261 Threads and O-Ring Sealing--Part 1: Ports with Recessed Conical Seat Requirements, Dimensions, Design, and Test Methods
- standard by SAE International, 08/12/2009
- Publisher: SAE
$37.00$74.00
This part of SAE J 2337 specifies dimensions, design, and performance requirements for eight ports using a conical seal to insure leak proof performance with a design factor of 4 to 1.These connectors are intended for general and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to the working pressures (shown in document). Since many factors influence the pressure at which hydraulic systems will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that the required performance levels are met.
Related Products
MIL MIL-P-7788
PLATE, PLASTIC, COCKPIT AND INTERIOR CONTROLS LIGHTING (S/S BY MIL-P-7788A) (SUPERSEDING AN-P-89)..
$12.00 $24.00
SAE AS1214B
Minimum Standards for Valve, High Pressure Oxygen, Line Shut Off, Manually Operated..
$37.00 $74.00
SAE AS5498
Minimum Operational Performance Specification for Inflight Icing Detection Systems..
$37.00 $74.00
SAE AS5258/5A
Insulating Components, Molded, Electrical, Heat Shrinkable, Boot, Strain Relief and Sealing, Straigh..
$37.00 $74.00