Provide PDF Format
SAE J968/1_200212
- Diesel Injection Pump Testing--Part 1: Calibrating Nozzle and holder assemblies
- standard by SAE International, 12/20/2002
- Publisher: SAE
$37.00$74.00
This part of SAE J 968 specifies two types of calibrating nozzle and holder assemblies intended for the testing and setting of diesel injection pumps on test benches.It applies to: a. a calibrating nozzle and holder assembly with a single hole orifice plate; and b. a calibrating nozzle and holder assembly with a delay pintle type nozzle.The approximate range of the calibrating nozzle and holder assembly is up to: a. 300 mm\u3/stroke with the single hole orifice plate; and b. 150 mm\u3/stroke with the delay pintle type nozzle. Setting and maintenance requirements are specified in ISO 4008/3.
Related Products
SAE AMS4893C
Alloy Castings, Corrosion and Heat-Resistant 66Ni - 29Cu - 4.0Si Solution Treated..
$37.00 $74.00
SAE AIR34A
PENALTIES IN PERFORMANCE OF THREE-PHASE, FOUR-WIRE, 400-CYCLE MOTORS CAUSED BY THE OPENING OF ONE PH..
$37.00 $74.00