Provide PDF Format
TAPPI T 541 om-05
- Internal Bond Strength of Paperboard (z-Direction Tensile)
- standard by Technical Association of the Pulp and Paper Industry, 09/25/2005
- Publisher: TAPPI
$34.00$68.00
1.1 This method describes a procedure for measuring the internal fiber bond strength (z-direction tensilestrength) of paperboard using an instrument that subjects a normal separation force to a 6.45-cm2 (1-in.2) specimen.
1.2 The procedure consists of applying double (two-sided) coated, pressure-sensitive tape to both sides of atest specimen. The specimen is then placed between two platens and compressed uniformly over the entire specimen surface area. Uniform tension is then applied over the entire test area in a direction perpendicular to the plane of the sample (z-direction) to affect a separation.
1.3 The test is intended for paperboards and some papers which have internal fiber bond strength (cohesivestrength) lower than the adhesive bond strength of the tape to the specimen and/or test platens. The material the platens are made from will affect the adhesive strength between platen and tape. The selection of tape may also affect test results. These effects may be seen as tape failures or in some cases higher test values caused by adhesive migrating into sample. The adhesive bond strength of the tape is critical to reproducible test results. New batches of tape should be tested for consistent bond strength. Bond strength can be tested by performing peel tests on standard test plates, or by testing a stable reference sample.
1.2 The procedure consists of applying double (two-sided) coated, pressure-sensitive tape to both sides of atest specimen. The specimen is then placed between two platens and compressed uniformly over the entire specimen surface area. Uniform tension is then applied over the entire test area in a direction perpendicular to the plane of the sample (z-direction) to affect a separation.
1.3 The test is intended for paperboards and some papers which have internal fiber bond strength (cohesivestrength) lower than the adhesive bond strength of the tape to the specimen and/or test platens. The material the platens are made from will affect the adhesive strength between platen and tape. The selection of tape may also affect test results. These effects may be seen as tape failures or in some cases higher test values caused by adhesive migrating into sample. The adhesive bond strength of the tape is critical to reproducible test results. New batches of tape should be tested for consistent bond strength. Bond strength can be tested by performing peel tests on standard test plates, or by testing a stable reference sample.
Related Products
TAPPI TIP 0304-09
The edge crush test (ECT): its relationship to box compression and its derivation from containerboar..
$25.00 $49.00
